Welcome! Log In Create A New Profile

Advanced

Error in generate G code

Posted by ravenous 
Error in generate G code
October 06, 2016 12:04AM
Hi to all!!
I just draw a very simple schematic in Eagle 7.6.0, but when i try to generate the Gcode the pcb G code show me this error!!!!!
What am i doing wrong??
And why the preview is so small, i cant enlarge , or make it bigger!!
Please help me, im novice in Eagle and in PCB G code!!!!!confused smiley
Attachments:
open | download - Error.PNG (49.7 KB)
open | download - Preview.PNG (12.6 KB)
Re: Error in generate G code
October 06, 2016 08:42AM
Hi,
Right now, can't think of anything to help you on the spindle speed error thing unless you have not set one up in the setup ulp??

Same thing goes for the preview page size as you can define it on the Generation Options tab of the setup ulp in the upper right hand corner:

Art
AKA Country Bubba
Attachments:
open | download - setupulp.jpg (6.3 KB)
Re: Error in generate G code
March 07, 2017 08:08AM
Hello Country Bubba,

i am new on this topic and i have the same problem with the error of "spindle_etch_RPM".
I am using pcb-gcode-ulp 3.6.04 and Eagle 6.6.0.
Can you tell me the solution for this problem.

Thanks for your answer.
Theoven.
Re: Error in generate G code
March 07, 2017 08:31AM
Theoven.
Once again, the only thing I can think of is that you don't have a spindle speed setup in the ULP. It is on the Machine tab in the setup.ulp in the lower left section of the screen. There are spindle speeds for each type of file to be generated.

Art
AKA Country Bubba
Sorry, only registered users may post in this forum.

Click here to login